You are viewing documentation for CompuTec WMS 2.0, which is supported until December 31, 2026. After this date, it will no longer receive regular support or maintenance updates.
We recommend upgrading to CompuTec WMS 3.0, which runs on CompuTec AppEngine 3.0 (.NET 8).
When upgrading, update all required CompuTec components together to ensure compatibility. Read more
Configure a USB Barcode Scanner
Before using a USB barcode scanner with CompuTec WMS, you must configure it with the required settings. The following sections provide model-specific configuration instructions.
Configure Honeywell MS5145 LS USB Scanner
To work correctly with CompuTec WMS, the Honeywell MS5145 LS USB scanner must be configured to send:
- Prefix:
002 - Suffix:
003
Follow the steps below to configure the USB scanner.
Before you start
Make sure you have access to the configuration barcodes for the Honeywell MS5145 LS USB scanner.
Configure the USB scanner
To configure the USB scanner, follow these steps:
-
Scan the Enable Factory Defaults barcode.
-
Scan the Recall Defaults barcode.
-
Scan the Enter/Exit Programming barcode to enter the programming mode.
-
Scan the Configurable Prefix #1 barcode.
-
Next, scan the following digits in order:
002.
This configures the scanner to send the prefix 002.
-
Scan the Configurable Suffix #1 barcode.
-
Next, scan the following digits in order:
003.
This configures the scanner to send the suffix 003.
-
Scan the Enter/Exit Programming barcode again to exit programming mode and save the configuration.
Result
The USB barcode scanner is now configured to send:
- Prefix:
002 - Suffix:
003
The device is ready to use with CompuTec WMS.